• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSPECT  HOOK  AND  CABLE  ASSEMBLY
REMOVE  HOOK  AND  CABLE  ASSEMBLY

TM-55-1520-240-23-10 UH-1H/V and EH-1H Aircraft Manual
Page Navigation
  314    315    316    317    318  319  320    321    322    323    324  
TM  55-1520-240-23-10 14-12 INSPECT HOOK AND CABLE  ASSEMBLY (Continued) 14-12 1. Disconnect  upper  half of quick  disconnect  cable guard  (1)  from  lower  half of cable  guard  (2). 2. Check  hook (3)  and  cable  (4)  for  corrosion. 3. Check  that  hook  (3)  turns freely.  If  it  does not, apply  light  coat  of  dry  lubricant  (E235)  to  pivot (5). 4. Check  safety  latch  (6)  for  cracks,  nicks,  and proper  spring  action. 5. Check  cable  (4)  for  broken  strands  or  fraying. (Refer  to  TM  1-1500-204-23.)   Trim  wire  ends flush  with  cable.   Use  cloth  (E135). 6. Check  upper  half of guard  (1)  and  lower  half  of cable  guard  (2).   There  shall  be  no  cracks  or stripped  thread. 7. Check quick-disconnect coupling  (7).  There  shall be  no  broken  spring  (8),  cracks, or  corrosion. 8. Remove  and  stow  hook  and  cable  assembly (9)  in  pocket  (10)  of  stowage  container  (11)  (if required)  (Task  14-13). FOLLOW-ON  MAINTENANCE: Install  heater  compartment  acoustic  blanket  (Task 2-210). END  OF  TASK 14-44







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.