• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL WINCH  WIRE  ROPE (CABLE) (Continued)
INSPECT  HOOK  AND  CABLE  ASSEMBLY

TM-55-1520-240-23-10 UH-1H/V and EH-1H Aircraft Manual
Page Navigation
  312    313    314    315    316  317  318    319    320    321    322  
TM  55-1520-240-23-10 14-11 INSTALL  WINCH  WIRE  ROPE  (CABLE) (Continued) 14-11 17. Pull  ball  end  (4)  up  through  winch  housing  (30). 18. Position  ball  end  (4)  in  socket  (31)  on  drum  (32). 19. Install  locking  sleeve  (33)  and  retaining  ring  (34). 20. Apply electric  and  hydraulic  power. 21. Bleed  utility  hydraulic  system. NOTE Keep  tension  on  wire  rope  when reeling  in  wire  rope.   Wire  rope  will reel  in  evenly  and  will  not  snarl. 22. Have  helper  keep  slight  drag  on  wire  rope  (1). Helper  must  wear  gloves  (E185). 23. Reel  in  one  wrap  of  wire  rope  (1) (TM  55-1520-240-T). 24. Raise  wrap  of wire  rope  (1)  and  install  end  cover (35)  in  socket  (31). 25. Make  sure  wire  rope  (1)  is pulled  tight  and  holds end  cover  (35)  in  place. INSPECT 26. Reel in  all  wire  rope  (1)  (TM  55-1520-240-T). 27. Shut down  electric and  hydraulic power. FOLLOW-ON  MAINTENANCE: Operate  winch  (TM  55-1520-240-T). Install  cockpit aft floor  panel  (Task 2-84). Install  heater  compartment  acoustic  blanket  (Task 2-210). END  OF  TASK 14-42







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.