• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
REMOVE  WINCH  WIRE  ROPE  CABLE (Continued) - TM-55-1520-240-23-10_346
INSTALL  WINCH  WIRE  ROPE  (CABLE) (Continued) - TM-55-1520-240-23-10_348

TM-55-1520-240-23-10 UH-1H/V and EH-1H Aircraft Manual
Page Navigation
  309    310    311    312    313  314  315    316    317    318    319  
TM  55-1520-240-23-10 14-11 INSTALL WINCH WIRE  ROPE  (CABLE) 14-11 INITIAL  SETUP Applicable Configurations: All Tools: Aircraft  Mechanic’s Tool  Kit, NSN  5180-00-323-4692 Container,  Two  Quart Materials: Cloths  (E120) Lockwire  (E229) Gloves,  Wire  Handling  (E185) Personnel  Required: Medium  Helicopter  Repairer  (2) Inspector References: TM  55-1520-240-23P TM  55-1520-240-T General Safety Instructions: Wear  wire  handling  gloves  when installing wire rope (cable).  Otherwise, injury to  hands  can  result. 1. Guide  wire  rope  (1)  through  bracket  (2)  and guard  (3)  until  cable  ball  end  (4)  extends past bulkhead  (5). 2. Position  pulley  (6)  forward  in  bracket  (2).   Wire rope  (1)  shall  be  forward  in  groove  (7)  of pulley. 3. Make  sure  two  washers  (8)  are  in  place  on  top and  bottom  of  pulley  (6). 14-39







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.