TM 55-1520-240-23-9
11-224
INSTALL LCT CONNECTING LINK LOWER FITTING BEARING (AVIM)
(Continued)
11-224
Carbon dioxide (dry ice) (E92)
causes severe burns (frost bite) and
gives off toxic fumes. Use only in
well-ventilated area. Do not get in
eyes, on skin, or clothing. In case of
contact, immediately flush with plenty
of water. Get medical attention for
eyes.
Methanol (E243) is flammable and
toxic. It can irritate skin and cause
burns. Use only in well-ventilated
area, away from heat and open flame.
In case of contact, immediately flush
skin or eyes with water for at least
15 minutes. Get medical attention
for eyes.
2.
Place bearing (3) in carbon dioxide (dry ice)
(E92) and methanol (E243). Wear Kevlar gloves
(E187). Allow bearing to cool thoroughly.
3.
Support link end fitting (2) in arbor press (4).
Bearing (3) must be inserted into fitting from
same side that old bearing was removed.
Wear Kevlar gloves (E187) when
handling chilled bearing.
NOTE
Work quickly with chilled bearing. It
must be installed before it warms.
4.
Remove bearing (3) from dry ice. Wear Kevlar
gloves (E187). Wipe clean and dry. Use cloth
(E120).
5.
Press bearing (3) into fitting (2) (TM
55-1500-322-24).
11-874
