TM 55-1520-240-23-9
11-217
INSTALL FORWARD LCT YOKE
(Continued)
11-217
8.
Install washer (8) and nut (7) on shaft (9). Torque
nut to 600 inch-pounds. Continue tightening
only as needed to align cotter pin holes. Do not
exceed 650 inch-pounds.
9.
If cotter pin holes will not align, remove nut (7)
and add one or two washers (8). Install nut and
repeat step 8.
10.
Check yoke (1) as follows:
a.
Apply force to lug (13). Use dial indicating
scale (16). Yoke must rotate with force not
greater than 80 pounds. Shaft (9) shall not
rotate in mount (10).
b.
Gap between washer (11) and surface of
mounting (10) shall not be less than 0.005
inch.
c.
There shall be no gap between bushing (18)
and bearing (19).
d.
There shall be no gap between bushing (20)
and bearing (21).
11.
Install cotter pin (22) in nut (7).
INSPECT
11-858