TM 55-1520-240-23-9
11-163.4
INSTALL DASH ACTUATOR ROD END BEARING
(Continued)
11-163.4
Epoxy primer (E292) is flammable
and toxic. It can irritate skin and
cause burns. Use only with adequate
ventilation, away from heat or open
flame. Avoid contact with skin, eyes
or clothing. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
6.
On lower rod end bearing only, coat roll pin (8)
with epoxy primer (E292). Wear gloves (E184.1)
and goggles.
7.
On lower rod end bearing only, install roll pin (8)
through hole (7) in actuator shaft (5) and rod
end bearing (4).
8.
On lower rod end bearing only, install lockwire
(E231) through roll pin (8) and around actuator
shaft (5).
9.
Remove actuator (1) from vise (2).
INSPECT
FOLLOW-ON MAINTENANCE:
Perform adjustment of differential airspeed hold
(DASH) actuator (Task 11-165).
END OF TASK
11-671