TM 55-1520-240-23-9
11-163.3
REMOVE DASH ACTUATOR ROD END BEARING
11-163.3
INITIAL SETUP
Applicable Configurations:
All
Tools:
Aircraft Mechanic’s Tool Kit, NSN 5180-00-323-4692
Vise, Soft Jaws
Materials:
None
Personnel Required:
Medium Helicopter Repairer
Equipment Condition:
Off Helicopter Task
NOTE
Upper or lower rod end bearing is
removed in same manner, except as
noted.
1.
Clamp lower DASH actuator (1) in vise (2).
2.
Remove lockwire (3).
3.
On lower rod end bearing only, using a drift, drive
out roll pin (4).
4.
Hold rod end bearing (5) with open end wrench.
Loosen checknut (6).
5.
Remove rod end bearing (5).
6.
Remove checknut (6) from rod end bearing (5).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
11-669
