TM 55-1520-240-23-9
11-85
REMOVE COCKPIT CONTROL TRANSFER CONNECTING LINKS
(Continued)
11-85
Wires must not support housing;
otherwise, damage to equipment
could occur.
2.
Remove left landing light housing (4) from access
(5). Support housing so it does not hang by
wires (6).
3.
Remove gasket (7) from housing (4).
4.
Strap housing (4) to access (5) at aft end with
strap (E376) (8). Wires (6) must not support
housing.
NOTE
Attaching bolts, washers, and nuts
will be temporarily installed after links
are removed.
REMOVE YAW AND ROLL TRANSFER CONNECTING
LINKS
5.
Move bellcrank (9) for access to bolt (10).
Remove cotter pin (11), nut (12), two washers
(13), and bolt from bellcrank.
6.
Tag and disconnect yaw connecting link (14)
from bellcrank (9).
7.
Install bolt (10), two washers (13), and nut (12) in
bellcrank (9).
8.
Move bellcrank (15) to align bolt (16) and hole
(17). Have helper in cockpit hold bolt (16).
9.
Remove cotter pin (18), nut (19), two washers
(20), and bolt (16).
10.
Tag and disconnect roll connecting link (21) from
bellcrank (15).
11.
Install bolt (16), two washers (20), and nut (19)
in bellcrank (15).
11-448
