TM 55-1520-240-23-9
11-42
RIG COCKPIT CONTROL ASSEMBLIES
(Continued)
11-42
47.
Working through left access (36) remove cotter
pin (66), nut (67), and washers (68) from bolt
(69) of bellcrank (70).
48.
Lift bolt (69) to release link (71). Disconnect link
from bellcrank (70). Lower bolt in bellcrank.
49.
Loosen nut (72) of link (71).
50.
Working in cockpit, install pin (63) in hole (64) of
pilot’s support (65) until fully down in hole.
51.
Check position of control (73). Distance ‘X’
between pivot block (74) and grip (75) must
not be more than 0.06 inch up or down from
distance measured in step 44 or 45. If distance
is same, go to step 53. If distance is not same,
perform step 52.
52.
Rig thrust control (Task 11-43).
11-171
