TM 55-1520-240-23-9
11-42
RIG COCKPIT CONTROL ASSEMBLIES
(Continued)
11-42
RIG THRUST CONTROLS
43.
Working in cockpit, install thrust rig pin (57) in
hole (58) of copilots control support (59). Move
thrust control (60) up or down until pin slides fully
down in hole.
44.
Check position of control (60). Measure and
record distance between pivot block (61) and grip
(62). Distance must be 5.10 to 5.70 inches. If
distance is same, go to step 46. If distance is not
same, perform step 45.
45.
Rig thrust control (Task 11-43).
46.
Install thrust rig pin (63) in hole (64) of pilots
control support (65). Pin must slide freely fully
down in hole. If pin slides fully down go to step
58. If pin does not slide fully down, perform steps
21 thru 24, then steps 47 thru 57.
11-170