TM 55-1520-240-23-9
11-32
RIG POSITION CHECK
(Continued)
11-32
14.
Check position of copilots control stick (10) as
follows:
a.
Measure distance between center of button
(16) and mark on label (13) on side frame
(14).
b.
Measure distance between center of button
(16) and mark on label (17) under VGI switch
(18).
c.
Measurements from steps a and b shall be
within 1/4 inch of measurement given on
labels (13 and 17).
d.
Stick position indicator (18.1) shall be 1.0
inch forward of N.
INSPECT
15.
Remove rig pin (20) from hole (19). Work from
forward left work platform.
NO BREAK - WORK HARDER
FOLLOW-ON MAINTENANCE:
Remove DASH dummy link (T42) (Task 11-27).
Install DASH actuator (Task 11-164).
Perform operational check of flight control system
(TM 55-1520-240-T).
Perform interference check of flight control system
(TM 55-1520-240-T).
Close forward and aft work platforms (Task 2-2).
Close tunnel covers (Task 2-2).
END OF TASK
11-108