TM 55-1520-240-23-9
11-276
ASSEMBLE AFCS COMPUTER UNIT (CONTROL BOX) (AVIM)
(Continued)
11-276
15.
Install gyroscope (44) as follows:
a.
Position gyro (44) in base (45). Make sure
receptacle (46) is up and align notch (47)
with pin (48).
b.
Install four screws (49) and clamps (50).
Use sealant (E345) on screws. Wear gloves
(E186).
c.
Install two brackets (51) on connector (52)
and position connector on gyro (44).
d.
Install two screws (53) in connector (52).
e.
Tie wire harness (19) to gyro (44). Use
braided tape (E403). Apply adhesive (E62) to
knots of braided tape. Wear gloves (E186).
16.
Install altitude transducer (54) as follows:
a.
Install tube (55) on transducer (54). Remove
tag.
b.
Position transducer (54) in base (2). Remove
tag.
c.
Position bracket (56) with terminal board (57)
over transducer (54) With wires (58) inward.
d.
Install two screws (59). Use sealant (E345)
on screws. Wear gloves (E186).
e.
Install tube (60) on tee fitting (61).
f.
Install tubes (39 and 55) on fitting (61).
g.
Install tube (60) on static fitting (62).
11-1063
