TM 55-1520-240-23-9
11-276
ASSEMBLE AFCS COMPUTER UNIT (CONTROL BOX) (AVIM)
(Continued)
11-276
2.
Position capacitor (4) on base circuit board (5),
turn board over and solder two leads (6).
3.
Tie capacitor (4) to base circuit board (5) at two
places (7). Use braided tape (E403). Apply
adhesive (E62) to knots of braided tape. Wear
gloves (E186).
Transformer must be installed with
assembly band splice toward center of
base circuit board to prevent damage
to electrical equipment in AFCS unit.
4.
Position transformer (8) on base circuit board (5).
Make sure assembly band splice (9) is toward
center of board.
5.
Turn board (5) over and solder 20 transformer
pins (10) and lug (11). Use solder (E360).
6.
Position choke (12), flat side down, with solder
terminals (13) toward capacitor (4).
7.
Install screw (14) and nut (15). Use sealant
(E345) on screw and nut. Wear gloves (E186).
8.
Solder two wires (16) to terminals (13) of choke
(12). Remove tags.
11-1060