TM 55-1520-240-23-7
9-136
ASSEMBLE PITCH AND ROLL CONTROL STICK GRIP (AVIM)
(Continued)
9-136
7.
Remove tape and solder five wires (11) to switch
(12). Remove tags. Use solder (E360).
8.
Position switch (12) in grip (3). Install bracket
(13), two screws (14), and washers (15).
9.
Remove tape and solder three wires (16) to
switch (17). Remove tags. Use solder (E360).
10.
Position switch (17) in grip (3). Install two screws
(18).
11.
Position trigger (19) on switch (17). Install pin (4).
12.
Install nut (20) loosely on grip (3).
13.
Install ball (21), spring (22), and screw (23). Turn
screw full clockwise then back out one and one
half turns. Tighten nut (20).
14.
Grease (E189) pin (24). Install pin, spring (25),
and nut (26).
15.
Install screw (27) and washer (28).
INSPECT
FOLLOW-ON MAINTENANCE:
None
END OF TASK
9-540