TM 55-1520-240-23-7
9-135
DISASSEMBLE PITCH AND ROLL CONTROL STICK GRIP (AVIM)
(Continued)
9-135
1.
Remove pin (1) from right side of trigger (2).
Remove trigger.
2.
Remove screw (3) and washer (4) from grip (5).
3.
Remove two screws (6). Remove switch (7)
through trigger opening (8).
4.
Tag and unsolder three wires (9) from switch (7).
5.
Remove two screws (10) and washers (11) from
bracket (12).
6.
Remove bracket (12) and switch (13).
7.
Tag and unsolder five wires (14) from switch (13).
Tape wire ends.
8.
Without 36 , remove screws (15) from switch
(16). Remove switch.
8.1.
With 36 , remove screw (15) from switch ring
guard (15.1) and switch (16). Remove switch
ring guard and switch.
9.
Tag and unsolder three wires (17) from switch
(16). Tape wire ends.
10.
Remove screw (18) from switch (19). Remove
switch.
11.
Tag and unsolder two wires (20) from switch (19).
Tape wire ends.
12.
Remove screw (21) from switch (22). Remove
switch.
13.
Tag and unsolder two wires (23) from switch (22).
Tape wire ends.
14.
Loosen nut (24). Remove screw (25), spring
(26), and ball (27). Remove nut (24).
15.
Remove screw cap (28), spring (29), and pin
(30).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
9-538
