TM 55-1520-240-23-7
9-72
DISASSEMBLE LANDING LIGHT ROTATING MECHANISM (AVIM)
(Continued)
9-72
6.
Tag and disconnect electrical lead (16) by
removing screw (17) and washer (18) from shaft
(19). Install screw and washer on shaft.
NOTE
Install screw and washer to retain
pivot bus shaft and contact until rotate
shaft is removed.
7.
Tag and unsolder two wires (20) from rotate limit
switch (21). Use soldering gun. Withdraw wire
harness (22) through hole in rotating mechanism
(4).
8.
Remove two screws (23), washers (24) and
motor (25).
9.
Remove two screws (26), two washers (27),
adapter (28), switch (21), and insulator (29).
10.
Remove two screws (30), four washers (31),
adjusting plate (32), and two posts (33).
11.
Remove screw (34), washer (35), and contact
(36).
12.
Remove screw (37), two washers (38), and stud
(39). Remove insulator (40).
13.
Remove screw (41), washer (42), and post (43).
14.
Remove two screws (44), washers (45), and
clamp (46).
9-244