TM 55-1520-240-23-7
8-40
INSTALL CRUISE GUIDE SIGNAL CONDITIONER
8-40
INITIAL SETUP
Applicable Configurations:
All
Tools:
Electrical Repairer’s Tool Kit, NSN 5180-00-323-4915
Materials:
Dry Cleaning Solvent (E162)
Cloths (E120)
Gloves (E186)
Personnel Required:
Aircraft Electrician
Inspector
References:
TM 55-1520-240-23P
TM 55-1500-323-25
Dry cleaning solvent (E162) is
combustible and toxic. It can irritate
skin and cause burns. Use only with
adequate ventilation, away from open
flame. In case of contact, immediately
flush skin or eyes with water for
at least 15 minutes. Get medical
attention for eyes.
1.
Clean bonding surfaces of signal conditioner (1).
Use dry cleaning solvent (E162), cloth (E120),
and gloves (E186).
2.
Position signal conditioner (1).
3.
Install four screws (2) and washers (3).
4.
Connect two electrical connectors (4 and 5).
Remove tags.
INSPECT
FOLLOW-ON MAINTENANCE:
Close right forward work platform (Task 2-2).
Perform operational check (TM 55-1520-240-T).
END OF TASK
8-126
