TM 55-1520-240-23-6
7-130
REPAIR SWIVELING SERVOCYLINDER (AVIM)
(Continued)
7-130
7.
Check eight holes (15) in two plates (11) for
elongation. There shall be no elongation.
8.
Coat bearing seat (16) area with epoxy primer
(E292) (Task 2-350.1). Wear gloves (E184.1).
9.
Install new bearing (13) in seat (16). Use arbor
press.
Make sure antirotation pads on
retainer plates are installed in
horizontal position. Otherwise,
servocylinder will be damaged.
10.
Position two plates (11) on mount (14) with
antirotation pads (17) as shown. Install four
rivets (10).
11.
Check rivets are flush. If not, file or grind off
excess metal. Coat rivets with epoxy primer
(E292) (Task 2-350.1). Wear gloves (E184.1).
7-586
