TM 55-1520-240-23-6
7-90
INSTALL INTEGRATED LOWER CONTROL ACTUATOR (ILCA) JAM SENSOR (AVIM)
7-90
INITIAL SETUP
Applicable Configurations:
All
Tools:
Hydraulic Repairer’s Tool Kit, NSN 5180-00-323-4891
Torque Wrench, 0 to 50 Inch-Pounds
Materials:
Lockwire (E229)
Parts:
Preformed Packing
Personnel Required:
Aircraft Pneudraulics Repairer
Inspector
References:
TM 55-1520-240-23P
NOTE
Procedure is same to install jam
sensor on roll, pitch or yaw, and thrust
actuator.
1.
Position sensor (1) and packing (2) on actuator
(3). Install four screws (4). Torque screws to 16
inch-pounds.
2.
Lockwire four screws (4). Use lockwire (E229).
INSPECT
FOLLOW-ON MAINTENANCE:
Perform ILCA test (Task 7-98).
END OF TASK
7-364
