TM 55-1520-240-23-6
7-34
INSTALL NO. 1 OR NO. 2 POWER CONTROL MODULE FILTER ELEMENT
(Continued)
7-34
NOTE
There are four filter elements, two
in No. 1 and two in No. 2 module.
Procedure is same to install any filter
element. No. 1 module is shown here.
NOTE
If diaphragm was removed, refer to
(Task 7-349) for proper installation.
1.
Install element (1) in filter bowl (2).
Hydraulic fluid (E199) is toxic. It can
irritate skin and cause burns. Avoid
inhaling. Use only with adequate
ventilation. Avoid contact with skin,
eyes, or clothing. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
Hydraulic fluid ejected under pressure
can cause injury to personnel.
Hydraulic fluid sprayed into the air is
a fire hazard.
Install element removal spring (2.1)
with weld down.
1.1.
Install element removal spring (2.1) into filter port
(3) of module (4).
2.
Install filter bowl (2), in filter port (3), of module
(4). Use cloths (E135) for spilled fluid. Tighten
filter bowl (2) hand tight. Wear gloves (E184.1).
3.
Lockwire filter bowl (2) to module (4). Use
lockwire (E231).
4.
Connect connector (5) to receptacle (6).
INSPECT
7-186
