TM 55-1520-240-23-6
7-36
INSTALL NO. 1 OR NO. 2 POWER CONTROL MODULE FILTER CHANGE
SWITCH
(Continued)
7-36
NOTE
There are four filter switches, two
in No. 1 and two in No. 2 module.
Procedure is same to install any filter
switch. No. 1 module is shown here.
1.
If not already installed, install one retainer (1)
and two packings (2) on switch (3).
2.
Install switch (3) in bowl (4) with connector
inboard.
3.
Lubricate screws (5) with hydraulic fluid (E199).
Install four screws (5) in switch (3). Torque
screws to 32 to 34 inch-pounds in diagonal
sequence.
4.
Lockwire screws (5). Use lockwire (E231).
7-191
