TM 55-1520-240-23-6
7-23
REMOVE NO. 2 FLIGHT CONTROL HYDRAULIC PUMP
(Continued)
7-23
NOTE
If a crack in the hydraulic pump casing
is suspected during removal, refer to
TM 1-1520-253-23.
1.
Tag and disconnect four hydraulic hoses (1)
from pump (2). Use tag (E264). Use container
and cloths (E120) for spilled fluid. Wear gloves
(E184.1).
2.
Remove four nuts (4) from studs (5).
3.
Remove pump (2).
4.
Cover pump mount on transmission with barrier
material (E81) or equivalent.
Dry cleaning solvent (E162) is
flammable and toxic. It can irritate
skin and cause burns. Use only in
well-ventilated area, away from heat
and open flame. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
5.
Remove gasket (5.1) from pump (2).
5.1.
Wipe grease off splines (5). Use cloths (E120)
with dry cleaning solvent (E162). Wear gloves
(E184.1).
5.2.
Protect spline (5) with barrier material (E81) and
tape (E388).
7-158
