TM 55-1520-240-23-6
7-22
REMOVE NO. 1 FLIGHT CONTROL HYDRAULIC PUMP
(Continued)
7-22
NOTE
If a crack in the hydraulic pump casing
is suspected during removal, refer to
TM 1-1520-253-23.
1.
Tag and disconnect four hydraulic hoses (1) from
pump (2). Use container and cloths (E120) for
spilled fluid. Wear gloves (E184.1).
2.
Remove four nuts (3) from studs (4).
3.
Remove pump (2).
3.1.
Cover pump mount on transmission with barrier
material (E81) or equivalent.
Dry cleaning solvent (E162) is
flammable and toxic. It can irritate
skin and cause burns. Use only in
well-ventilated area, away from heat
and open flame. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
NOTE
When removing a Stratopower/
Dynapower pump there is a metal
shim bonded to pump flange. If this
shim comes unbonded from the
pump flange. It does not have to be
rebonded for installation.
3.2.
Remove gasket (5.1) from pump (2).
3.3.
Wipe grease off splines (5). Use cloths (E120)
with dry cleaning solvent (E162). Wear gloves
(E184.1).
4.
Protect spline (5) with barrier material (E81) and
tape (E388).
7-155
