TM 55-1520-240-23-5
6-24
INSTALL COMBINING TRANSMISSION AFT OUTPUT SHAFT ADAPTER ASSEMBLY
6-24
INITIAL SETUP
Applicable Configurations:
All
Too/s:
Aircraft Mechanic’s Tool Kit, NSN 5180-00-323-4692
Torque Wrench, 700 to 1600 Inch-Pounds
Workstand
Materials:
Dry Cleaning Solvent (E162)
Grease (E190.1)
Cloths (E120)
Gloves (E186)
Grease (E75)
Personnel Required:
Medium Helicopter Repairer
Inspector
References:
TM 55-1520-240-23P
Dry cleaning solvent (E162) is
flammable and toxic. It can irritate
skin and cause burns. Use only in
well-ventilated area, away from heat
and open flame. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
1.
Clean splines on aft output shaft (1) and adapter
assembly (2). Use dry cleaning solvent (E162)
and cloths (E120). Wear gloves (E186) and
goggles.
2.
Pack splines on shaft (1) and adapter assembly
(2) with grease (E190.1).
3.
Install adapter assembly (2) on shaft (1). Wipe
off excess grease with cloths (E120).
6-69
