TM 55-1520-240-23-5
6-25
INSTALL AFT TRANSMISSION ADAPTER ASSEMBLY
(Continued)
6-25
Dry cleaning solvent (E162) is
flammable and toxic. It can irritate
skin and cause burns. Use only in
well-ventilated area, away from heat
and open flame. In case of contact,
immediately flush skin or eyes with
plenty of water for at least 15 minutes.
Get medical attention for eyes.
1.
Clean splines of adapter assembly (1) and input
shaft (2). Use dry cleaning solvent (E162) and
clean cloths (E120). Use gloves (E186).
2.
Coat packing (3) with grease (E190.1). Install
packing on adapter assembly (1).
INSPECT
3.
Pack splines of input shaft (2) and adapter
assembly (1) with grease (E190.1).
4.
Align adapter assembly (1) with adapter
assembly (4) of No. 8 drive shaft (5). Install
adapter assembly in input shaft (2). Make sure
assembly is fully seated. Do not disturb position
of input shaft (2) or No. 8 drive shaft.
5.
Wipe off excess grease with cloths (E120).
FOLLOW-ON MAINTENANCE:
Phase rotor blades (Task 6-28).
Install No. 9 drive shaft (Task 6-29).
Install aft transmission drip tray (Task 2-3).
Close baffles under aft transmission (Task 2-2).
Close cargo ramp (Task 2-2).
END OF TASK
6-72
