TM 55-1520-240-23-5
6-4
REMOVE NO. 7 DRIVE SHAFT
6-4
INITIAL SETUP
Applicable Configurations:
All
Tools:
Aircraft Mechanic’s Tool Kit, NSN 5180-00-323-4692
Materials:
Barrier Material (E80)
Cloths (E120)
Personnel Required:
Medium Helicopter Repairer (2)
Equipment Condition:
Battery Disconnected (Task 1-39)
Electrical Power Off
Pylon Hinged Fairing Open (Task 2-2)
Pylon Lower Fairing Raised (Task 2-2)
Forward Drive Shaft Tunnel No. 6 Access Cover
Open (Task 2-2)
Remove Cabin Tunnel Smoke Baffle (Task 2-170.1)
Do not allow bolts to turn. If bolts turn,
bolts and adapter assembly can be
damaged.
NOTE
If more than one bolt is removed from
each adapter assembly, assembly will
have to be balanced.
1.
Remove one nut (1), special washer (2), and bolt
(3) from adapter assemblies (4 and 5). During
removal, hold head of bolts with wrench.
Do not allow bolts to turn. If bolts turn,
bolts and plates can be damaged.
2.
Remove three nuts (6) and washers (7) from
bolts (8) at each end of shaft (9). During removal,
hold head of bolts with wrench. Do not remove
bolts at this time.
6-19
