TM 55-1520-240-23-5
6-3
REMOVE NO. 2 THRU NO. 6 FORWARD DRIVE SHAFT
(Continued)
6-3
NOTE
Remove any of shafts No. 2 thru No.
6 in same way. Typical shaft shown
here.
REMOVE END NUTS
Do not allow bolts to turn. If bolts turn,
bolts and plates can be damaged.
1.
Remove nuts (1) and washers (2) from three
bolts (3) at each end of shaft (4). During removal,
hold head of bolts with wrench. Do not remove
bolts at this time.
Do not allow bolts to turn. If bolts turn,
bolts and adapter assembly can be
damaged.
NOTE
If more than one bolt is removed from
each adapter assembly, assembly will
have to be balanced.
2.
Remove one nut (5), special washer (6), and
bolt (7) from adapter assembly (8) at each end
of shaft (4). During removal, hold head of bolts
with wrench.
6-16