TM 55-1520-240-23-5
6-80
ASSEMBLE AFT TRANSMISSION SUMP
(Continued)
6-80
1.
Coat packing (1) and thread of temperature
probe (2) with oil (E254) Install packing on probe.
Install temperature probe in sump (3). Torque
probe to 75 inch-pounds.
2.
Lockwire probe (2) to sump (3). Use lockwire
(E231).
3.
If cap (4) and housing (5) are joined, push cap
into housing, twist, and pull. Remove cap from
housing.
NOTE
If cap and housing are new, cleaning
is not needed.
4.
Clean cap (4) and housing (5). Use dry cleaning
solvent (E162) and cloths (E120). Wear gloves
(E186).
5.
Install packing (6) on housing (5). Install housing
in sump (3). Install three bolts (7) and washers
(8). Torque bolts to 60 inch-pounds.
6.
Lockwire three bolts (7) together. Use lockwire
(E231).
7.
Press center of cap (4) in. Install cap and packing
(9) in housing (5). Push in cap until center snaps
out flush with outside of housing.
8.
Coat packing (10) and thread of drain valve (11)
with oil (E254). Install packing on valve. Install
drain valve in sump (3). Torque valve to 75
inch-pounds.
9.
Lockwire drain valve (11) to sump (3). Use
lockwire (E231).
6-307
