TM 55-1520-240-23-5
6-46
REMOVE FORWARD TRANSMISSION PACKAGE
(Continued)
6-46
REMOVE BOLTS (ALTERNATE METHOD)
NOTE
Torque applicator and reactor are part
of torque reactor assembly (T159).
22.4.
Loosen left bolt (49) as follows:
a.
Install socket adapter (T93) (52.7) on left
bolt (49).
b.
Install torque applicator (50) with large
hole over drive of socket adapter (T93)
(52.7). Observe THIS SIDE UP stamping on
applicator.
c.
Install sleeve (50.1) on aft of applicator (50).
Insert two pins (50.2) through sleeve and
adapter.
d.
Install aft end of sleeve (50.1) in center block
(50.3) of reactor (51). Install socket at end of
reactor on aft bolt (51.1).
e.
Install pin (51.2) through center block (50.3)
and applicator (50).
f.
Install torque applicator pack (T2) (52.8) on
drive of socket adapter (52.7). Rotate pack
so that two pins on bottom fit into holes (52.9)
in applicator (50). Use socket wrench speed
handle.
g.
Install speed handle on torque pack (T2)
(52.8). Turn handle counterclockwise until
torque is broken.
h.
Turn speed handle clockwise until torque
indicator (52.10) reads 0 and torque pack is
loose.
i.
Remove torque pack (52.8) and torque
reactor assembly (T159).
j.
Remove sleeve (50.1) from applicator (50).
k.
Do not remove left bolt (49).
6-158
