TM 55-1520-240-23-5
6-30
REMOVE ENGINE DRIVE SHAFT (Continued)
6-30
REMOVE ADAPTER ASSEMBLIES
NOTE
On shafts (Without 51 ), shaft and
adapter assemblies are balanced
together and have the same serial
number. If any one must be replaced,
all three must be replaced as a unit.
On shafts (With 51 ), shaft and their
adapters may be replaced individually.
6.
Remove adapter assembly (9) from combining
transmission (11) as follows:
a.
Pull adapter assembly (9) from splines of
input shaft (12).
b.
Remove packing (13) from shaft (12).
c.
Loosely install bolt (8), washer (7), and nut
(6) on adapter assembly (9).
d.
If a riveted shaft (1) has been removed,
loosely install adapter assembly (9) on drive
shaft with three bolts (5), washers (4), and
nuts (3).
7.
Remove adapter assembly (10) from engine
transmission (14) as follows:
a.
Remove nut (15) and washer (16).
b.
Pull adapter assembly (10) from splines of
output shaft (17). Remove packing (18) from
adapter assembly.
c.
Loosely install bolt (8), washer (7), and nut
(6) on adapter assembly (10).
d.
If a riveted shaft (1) has been removed,
loosely install adapter assembly (10) on drive
shaft with three bolts (5), washers (4), and
nuts (3).
FOLLOW-ON MAINTENANCE:
Inspect engine drive shaft (Task 6-30.3).
Task 6-30.1 deleted.
END OF TASK
Change 1
6-86.1/(6-86.2 blank)
