TM 55-1520-240-23-4
5-49
INSPECT AND ADJUST INTERPOSER SUPPORT SPRING-BACK
(Continued)
5-49
4.
Check that balancing arm stop (7) rests against
trailing lug (8).
5.
Measure distance between interposer block (6)
and hub (9). Distance shall be 0.000 inch to
0.070 inch. Use feeler gage.
6.
Measure distance between interposer block (6)
and striker block (10). Distance shall be 0.005 to
0.010 inch measured at both ends of interposer
block. Use feeler gage.
NOTE
If distance between interposer block
and striker block is between 0.005
and 0.010 inch, go to step 8.
If distance between interposer block
and striker block is not between 0.005
and 0.010 inch, go to step 7.
7.
Adjust interposer support (15) as follows:
a.
Insert socket-head screw key (11) in two blind
bolts (12). Loosen two locknuts (13). Use
open-end wrench (14).
b.
Slide slotted interposer support (15) until
distance between interposer block (6) and
striker block (10) is between 0.005 and 0.010
inch. Distance must be equal at both ends.
c.
Insert socket-head screw key (11) in two blind
bolts (12). Tighten two locknuts (13). Use
open-end wrench (14).
5-226
