TM 55-1520-240-23-3
3-28
CONVERT AFT LEFT TO AFT RIGHT LANDING GEAR
(Continued)
3-28
9.
Remove two cotter pins (14), nuts (15), bolts
(16), packing retainers (17), and washers (18)
from axle housing (19).
10.
Remove axle housing (19) from spindle (9).
11.
Rotate axle housing (19) 180º so axle (10) is on
aft side of spindle (9).
12.
Position axle housing (19) on spindle (9). Make
sure bolt holes are aligned.
13.
Install two bolts (16), four packing retainers (17),
four washers (18), nuts (15), and two cotter pins
(14).
14.
Remove cotter pin (20), nut (21), washer (22),
packing retainer (23), bracket (24), bolt (25), and
packing retainer (26).
15.
Rotate bracket 180º and install bolt (25), new
packing retainers (26), bracket (24), new packing
retainer (23), washer (22), nut (21), and cotter
pin (20).
16.
Remove four bolts (27) and washers (28).
Remove swivel lock actuator (29).
17.
Remove two nuts (30), washers (31), and bolts
(32). Remove clevis rod end (33).
18.
Position clevis rod end (33) in other hole in
actuating piston rod (34). Install two bolts (32),
washers (31), and nuts (30).
3-72
