TM 55-1520-240-23-3
4-110
REMOVE ACTUATOR SUPPORT BRACKET
4-110
INITIAL SETUP
Applicable Configurations:
Without 74
Tools:
Powerplant Repairer’s Tool Kit, NSN
5180-00-323-4944
Container, 2 Quart
Materials:
Cloths (E135)
Personnel Required:
Aircraft Powerplant Repairer
Equipment Condition:
Battery Disconnected (Task 1-39)
Electrical Power Off
Engine Work Platform Open (Task 2-2)
Engine Access Cover Open (Task 4-49)
Gas Producer Control Actuator Removed (Task
4-108)
Power Turbine Control Actuator Removed (Task
4-138)
NOTE
Procedure is same to remove actuator
support on No. 1 or No. 2 engine. No.
1 engine is shown here.
1.
Remove four nuts (1) and washers (2) from studs
(3).
2.
Remove bracket (4). Use container to catch any
oil spill. Clean up spilled oil. Use cloths (E135).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
4-395
