TM 55-1520-240-23-3
4-29.1
REMOVE FORWARD ENGINE MOUNT ADAPTER
(Continued)
4-29.1
10.
Remove lockwire from two bolts (41) on two
forward engine mount caps (42). Loosen bolts
(41) and push down.
All engine hoses and cable clamps
attached to the airframe must be
disconnected and hose and cable
routing must be clear before lifting
engine. Damage to equipment will
occur if hoses or cable clamps are left
attached or engine hoses and cables
become entangled.
INSPECT
During raising and lowering of
powerplant to adapter, make sure
bearing in aft engine mount link does
not tilt in clevis. If bearing tilts, it will
wedge in clevis, causing damage to
bearing and clevis.
11.
Raise hoist (34) slowly to lift powerplant (27) 2
to 3 inches above installed position. Make sure
bearing (43) in aft link (44) does not tilt in aft
engine mount clevis (40).
REMOVE ADAPTER
12.
Remove lockwire from 4 bolts (45). Remove four
bolts and washers (46).
13.
Remove adapter (47).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
4-166
