TM 55-1520-240-23-3
4-32
REPAIR FORWARD ENGINE MOUNT ADAPTER AND CAP
(Continued)
4-32
9.
Push bolts (6) out and down.
10.
Remove cap (2) and bearing (5) from adapter (4).
11.
If gap (7) measured in step 7, is less than 0.010
inch, dress facing surfaces (8) in equal amounts,
with fine aluminum oxide abrasive cloth (E1),
supported on a flat surface. Continue until a
gap of 0.010 to 0.070 inch exists. Do not paint
surfaces.
12.
If gap (7) is greater than 0.070 inch. Replace
cap (2) and adapter (4).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
4-171
