TM 55-1520-240-23-3
3-85
INSTALL AFT BRAKE
3-85
INITIAL SETUP
Applicable Configurations:
All
Tools:
Aircraft Mechanic’s Tool Kit, NSN 5180-00-323-4692
Torque Wrench, 100-750 Inch-Pounds
Materials:
Antiseize Compound (E75)
Sealing Compound (E336)
Epoxy Primer (E292.1)
Gloves (E184.1)
Goggles (E473)
Parts:
Packing
Personnel Required:
CH-47 Helicopter Repairer
Inspector
References:
Task 3-35
TM 55-1520-240-23P
WARNING
Epoxy primer (E292.1) is flammable
and toxic. It can irritate skin and
cause burns. Use only with adequate
ventilation, away from heat or open
flame. Avoid contact with skin, eyes,
or clothing. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
NOTE
Procedure is same for left and right
brakes. Left gear shown here.
1.
Apply primer (E292.1) to mating surfaces of axle
flange (1) and brake (2). Wear gloves (E184.1).
2.
Position brake (2) with disk (3) on axle flange (1).
3.
Align bolt holes of brake (2) and flange (1). Make
sure brake is in position to match brake tube (4).
Change 1
3-219
