TM 55-1520-240-23-3
3-83
INSTALL FORWARD BRAKES
(Continued)
3-83
3.
Position brake (3) with brake disk (6) on axle
flange (5) as follows:
a.
Brake (3) must be on forward side of axle (7).
b.
Union (2) must be horizontal.
c.
Brake (3) bolt holes must align with holes in
axle flange (5).
Antiseize compound (E75) can form
toxic vapors if exposed to flame. Use
in well-ventilated area away from open
flame. In case of contact, immediately
flush skin or eyes with water for
at least 15 minutes. Get medical
attention for eyes.
4.
Apply antiseize compound (E75) to shanks of
bolts (8 and 9). Use brush (E86). Wear gloves
(E184.1).
NOTE
Longer bolts are installed on forward
left outboard and right inboard brakes.
To install bolts in left outboard or right
inboard brakes, perform steps 5 and
7. To install bolts in left inboard or
right outboard brakes, perform steps
6 and 7.
5.
Install two long bolts (8), six shorter bolts (9),
16 washers (10 and 11), and eight nuts (12) on
forward left outboard or right inboard brake (3)
only. Make sure long bolts go through air valve
bracket (13).
6.
Install eight bolts (9), washers (10), washers
(11), and nuts (12) on forward left inboard or right
outboard brake (3) only.
7.
Torque eight nuts (12) to 105 inch-pounds.
3-215
