TM 55-1520-240-23-3
3-81
ASSEMBLE BRAKES
(Continued)
3-81
5.
Install retainer (15) on piston (16).
6.
Install packings (17 and 18) on cylinder head
(19).
7.
Position and hold cylinder head (19) against
piston (16). Using arbor press, install washer
(20) and three grips (21) on pin of piston. Make
sure grips are against cylinder head.
NOTE
Hold cylinder head in position on
piston until nut is installed.
8.
Install bushing (22) on cylinder head (19). When
bushing bottoms, back off 1/2 turn.
9.
Install nut (23) on pin of piston (16).
10.
Install cylinder head assembly (24) in brake
housing (2) with cylinder head flush with housing.
Use spanner (APP E-35).
11.
Repeat steps 5 thru 10 for the remaining two
cylinder head assemblies (25 and 26).
Use all asbestos or all non-asbestos
brake linings in any single brake
assembly. Brake assemblies
containing asbestos linings and brake
assemblies containing non-asbestos
linings may be used on the same
aircraft.
12.
Install linings (27) (Task 3-76).
13.
Install disk (28) (Task 3-74).
14.
Lockwire nuts (23) together. Use lockwire (E230).
INSPECT
FOLLOW-ON MAINTENANCE:
None
END OF TASK
3-212
