TM 55-1520-240-23-10
16-35
INSTALL FORWARD OR AFT CARGO HOOK INTERNAL MANUAL RELEASE
CABLE
(Continued)
16-35
NOTE
Procedure is same to install forward or
aft cargo hook internal manual release
cable except as noted. Forward cable
shown here.
1.
Route cable (1) through floor beams and install
in feed-thru fitting (2).
2.
Tighten cable retaining nut (3). Lockwire
retaining nut. Use lockwire (E231).
NOTE
On aft cargo hook interior manual
release cable there are two support
clamps.
3.
Install three support clamps (4) on cable (1).
The clamps at sta 280 and 300 must
be positioned with the cable outboard
of the damp retaining bolt. This places
the cable between floor "I" sections;
not under one, where the cable could
be crushed.
4.
Working under aircraft at forward cargo hook
feed-thru fitting (2), pull out cable attachment (5).
5.
Slide ball end attachment (6) of cable (1) into
recess in cable attachment (5).
6.
Slide outer sleeve (7) up cable (1) and position
over fitting (2).
7.
Tighten nut (8) on fitting (2).
16-187
