• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ADJUST PITCH,  ROLL OR  YAW SPRING  ASSEMBLY  (AVIM)
ADJUST PITCH, ROLL OR YAW  SPRING  ASSEMBLY  (AVIM) (Continued) - TM-55-1520-240-23-9_633

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  605    606    607    608    609  610  611    612    613    614    615  
TM  55-1520-240-23-9 11-145 ADJUST PITCH, ROLL OR YAW  SPRING  ASSEMBLY  (AVIM) (Continued) 11-145 5. Remove  cotter pin  (6), nut  (7), washer (8),  piston (9),  and  shims  (10), from  rod  (5).   If  spring  force is  high, remove  shims as required.  If  spring  force is  low,  add  shims  as  required. NOTE One  shim  changes  spring  force  as follows: PITCH ROLL YAW 0.42 pounds 0.31 pounds 0.94 pounds 6. Install  shims (10),  piston  (9),  washer (8),  and  nut (7).  Torque  nut to  25  to 35  inch-pounds.  Install an  AN960-416(L) washer (8.1) between  washer (8)  and  nut  (9)  as required  to  align  cotter  pin, install  cotter  pin  (6). INSPECT 7. Install  rod  (5), spring  (11),  inward  in  housing  (2). Antiseize  thread  compound  (E75) can form  toxic vapors  if exposed  to  flame. Use  only  with  adequate  ventilation, away  from  open  flame.   In  case  of contact, immediately flush skin  or eyes with  water for  at  least  15 minutes. Get medical  attention  for eyes. 8. Apply a  thin  coat of antiseize  thread  compound (E75)  to  threads  of cap  (4).  Use  gloves  (E184.1). Install  cap  (4) on  housing  (2).  Torque  cap  to  135 inch-pounds. INSPECT 9. Remove  housing  (2) from  vise  (3). 11-616







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.