• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
TEST PITCH,  ROLL OR  YAW  SPRING  ASSEMBLY  (AVIM) (Continued)
ADJUST PITCH, ROLL OR YAW  SPRING  ASSEMBLY  (AVIM) (Continued) - TM-55-1520-240-23-9_632

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  604    605    606    607    608  609  610    611    612    613    614  
TM  55-1520-240-23-9 11-145 ADJUST PITCH,  ROLL OR  YAW SPRING  ASSEMBLY  (AVIM) 11-145 INITIAL  SETUP Applicable Configurations: All Tools: Aircraft  Mechanic’s Tool  Kit, NSN  5180-00-323-4692 Soft  Jawed  Vise Torque  Wrench,  5  to  50  Inch-Pounds Torque  Wrench,  30  to  150  Inch-Pounds Materials: Lockwire  (E231) Cloth  (E120) Gloves  (E184.1) Antiseize  Thread  Compound  (E75) Parts: Shim  Washers Cotter  Pin Personnel  Required: Medium  Helicopter  Repairer Inspector References: TM  55-1520-240-23P Task  11-144 Equipment  Condition: Off  Helicopter  Task Pitch,  Roll  or  Yaw  Spring  Assembly  Tested  (Task 11-144) Do  not  lubricate  any  parts  of  spring assembly, except  as  noted; otherwise, component  malfunctions can  occur. NOTE Wipe  all  components  with  dry cloth (E120). 1. Clamp  bearing  end  (1)  of  housing  (2)  in  vise  (3). 2. Remove  lockwire  from  end  cap  (4). 3. Remove  cap  (4)  from  housing  (2).   Turn  cap counterclockwise. 4. Pull  rod  (5)  outward  from  housing  (2).  Remove rod  from  housing. 11-615







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.