• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL  STICK  PITCH  POSITION  INDICATOR - TM-55-1520-240-23-9_459
INSTALL  STICK  PITCH  POSITION INDICATOR (Continued) - TM-55-1520-240-23-9_461

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  435    436    437    438    439  440  441    442    443    444    445  
TM  55-1520-240-23-9 11-84 INSTALL  STICK  PITCH  POSITION INDICATOR (Continued) 11-84 12. Working  through  access  (37),  slide  tube  (39) forward  until  about  1 inch  of  cable  (12) shows from  end  of  tube. 13. Install  collet  (43)  on  cable  (12),  about  0.4  inch from  end  of  cable.   Turn  clockwise. 14. Pull  tube  (39) aft until collet bottoms in  tube. 15. Install  bearing  (44) in  tube  (39) until  bottomed. Turn  clockwise. 16. Check  bearing  (44).  Move  bearing  fully forward and  fully  aft  using  dial  indicating  scale  (45). Force  required  to  move  bearing  shall  be  less than  1  pound. 17. Move  bellcrank arm  (46) forward  and  slide  tube (39)  aft.  Align  bearing  (44) with  hole  (47) in  arm. 18. Position  washer  (48) between  bearing  (44)  and arm  (46).  Install  bolt  (49),  two  washers  (50  and 51) and  nut (52).  Do  not  tighten  nut  at this time. 19. Rig  stick position  indicator (Task  11-45). 11-444







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.