• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL THRUST CONTROL (PILOT) (Continued) - TM-55-1520-240-23-9_316
INSTALL THRUST CONTROL (PILOT) (Continued) - TM-55-1520-240-23-9_318

TM-55-1520-240-23-9 CH-47D Heilcopter Manual
Page Navigation
  292    293    294    295    296  297  298    299    300    301    302  
TM  55-1520-240-23-9 11-66 INSTALL THRUST CONTROL (PILOT) (Continued) 11-66 6. Remove  nut  (14),  washers (15),  and  bolt  (16) from  bellcrank (17).  Make  sure  bushings are  in place  in  bellcrank. 7. Position  thrust  control  bottom  link  (18)  in bellcrank  (17).   Install  bolt  (16),  head  outboard, two  washers (15), and  nut (14).  Torque  nut to  30 to 46 inch-pounds.  Install  cotter pin  (19). 8. Check  bolt  (16).   Bolt  shall  not  rotate  with  a torque  less  than  10 inch-pounds.  Bolt  shall  not have  axial  looseness.  If bolt  rotates  or is  loose, add  washer  under  nut.   Torque  and  cotter pin nut  again. INSPECT 9. Connect  electrical  connector (20) to  receptacle (21) on  bulkhead  (22). 10. Install  two  cable  clamps  (23) on  cable  (7). 11. Install  two  spacers  (24), two  clamps (23),  and two  nuts  (25)  on  two  screws  (26) in  console panel  (27). INSPECT 11-301







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.