• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
TEST TORQUEMETER  POWER  SUPPLY  (AVIM)
INSTALL ENGINE  TORQUEMETER  POWER  SUPPLY

TM-55-1520-240-23-7 CH-47D Heilcopter Manual
Page Navigation
  58    59    60    61    62  63  64    65    66    67    68  
TM  55-1520-240-23-7 8-21 TEST  TORQUEMETER  POWER SUPPLY  (AVIM) (Continued) 8-21 TEST  TORQUEMETER POWER SUPPLY 1. Connect  torquemeter  power  supply  (1)  to  test setup. 2. Set electronic  counter  (2)  to  minimum  time  base of  10  seconds. 3. Turn  on  power  supply  (3)  and  adjust  power supply  (3)  to  30  vdc. 4. Adjust resistance  decade  (4)  to  20 ohms. 5. Set switch  (5)  to  ON. 6. Set switch  (6)  to  7.5 mH  position  (closed).  Check voltmeter  (7).   Voltmeter  shall  read  537 to 543 millivolts.  Check electronic counter  (2).  Counter shall  read  1,995  to 2.005  Hz. 7. Adjust resistance  decade  (4)  to  30 ohms.  Check voltmeter  (7)  and  counter  (2).  Readings shall be same  as  readings  in  step  6. 8. Set switch  (6)  to  8.8 mH  position  (open).  Check voltmeter  (7)  and  counter  (2).  Readings shall be same  as  readings  in  step  6. 9. Adjust resistance  decade  (4)  to  20 ohms.  Check voltmeter  (7)  and  counter  (2).  Readings shall be same  as  reading  in  step  6. 10. Adjust power  supply (3)  to  24 vdc.  Repeat  steps 6  thru  9.   Check  voltmeter  (7)  and  counter  (2). Readings at each  step  shall be  same  as readings in  step  6. SHUTDOWN 11. Set switch  (5)  to  OFF. 12. Shutdown  power  supply  (3). 13. Disconnect  torquemeter  power  supply  (1)  from test  setup. INSPECT FOLLOW-ON  MAINTENANCE: None END  OF  TASK 8-66







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.