• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
REPLACE  TAIL POSITION LIGHT LAMP
INSTALL  SIDE  POSITION  LIGHT

TM-55-1520-240-23-7 CH-47D Heilcopter Manual
Page Navigation
  574    575    576    577    578  579  580    581    582    583    584  
TM  55-1520-240-23-7 9-66 REMOVE  SIDE  POSITION  LIGHT 9-66 INITIAL  SETUP Applicable Configurations: All Tools: Electrical  Repairer’s Tool Kit, NSN 5180-00-323-4915 Soldering  Gun Materials: Tape  (E397) Personnel  Required: Aircraft  Electrician  (2) Equipment  Condition: Battery Disconnected  (Task  1-39) Electrical  Power Off Forward  Landing  Gear Access Panel  Open  (Task 2-2) NOTE Procedure  is same  for removing  left  or right  position  light.   Right  side  light is shown  here. 1. Remove  screw  (1),  lens  (2),  and  lamp  (3) from light  (4). 2. Disconnect electrical socket (5) from back of light. 3. Unsolder  wire  (6) from  socket (5).  Tape  exposed end.   Use  tape  (E397). 4. Remove  three  washers  (8)  and  nuts  (9)  from screws  (7). 5. Remove  three  screws  (7) and  light (4). FOLLOW-ON MAINTENANCE: None END  OF  TASK 9-227







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.