INSTALL TAIL POSITION LIGHT
Acetone (E20) is flammable and toxic.
It can irritate skin and cause burns.
Use only in well-ventilated area, away
from heat and open flame. In case
of contact, immediately flush skin
or eyes with water for at least 15
minutes. Get medical attention for
Remove old sealant (10) from fuselage (11). Use
acetone (E20). Wipe with cloth (E120). Wear
Remove tape and connect two wires (12) to
terminals (8 and 9). Install screws (6) and
washers (7). Remove tags.
Position light (1) in fuselage (11) and install two
Install seal (5), lens (4), retaining ring (3) and
two screws (2).
Sealant (E336) can irritate skin and
cause burns. Avoid contact with skin,
eyes, and clothing. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
Seal outer edge of light (1). Use sealant (E336).
Perform operational check (TM 55-1520-240-T).
END OF TASK