• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL COMBINING TRANSMISSION OIL COOLER  FAN  AND SHAFT 145D5319-7
INSTALL  COMBINING  TRANSMISSION  OIL  COOLER  FAN  AND  SHAFT 145D5319-7 (Continued) - TM-55-1520-240-23-5_636

TM-55-1520-240-23-5 CH-47D Heilcopter Manual
Page Navigation
  599    600    601    602    603  604  605    606    607    608    609  
TM  55-1520-240-23-5 6-186.1 INSTALL  COMBINING  TRANSMISSION  OIL  COOLER  FAN  AND  SHAFT 145D5319-7 (Continued) 6-186.1 1. With  retaining  nut  (1) of  fan  (2) facing  up,  set the fan  on  a  firm  surface. Overgreasing  can  damage  fan. 2. Pump  grease  (E190) into  grease  fitting  (3)  of fan (2)  until  grease  comes  out  of  vent  fitting  (4).  Do not  overgrease  the  fan. 3. Coat four studs (5) on oil cooler (6) with  oil (E253, E254, or  E254.1).  Install  fan  (2) on  the  studs. 4. Install  nuts (7) on  studs  (5).  Torque  nuts  to  5 to 15 inch-pounds above  run-on  torque. 5. Slowly  rotate  fan  impeller  assembly  (8).  Check that  the  lower  impeller  does  not  rub  against baffle  (9). 6. Remove  nuts (7) from  studs (5).  Remove  fan  (2) from  cooler  (6). Dry  cleaning  solvent  (E162)  is flammable  and  toxic.   It  can  irritate skin  and  cause  burns.   Use  only  in well-ventilated  area, away  from  heat and  open  flame.   In  case  of contact, immediately flush  skin  or eyes  with water  for  at  least 15 minutes.   Get medical  attention  for eyes. 7. Clean  splines (10)  at each  end  of  shaft (11).  Use dry  cleaning  solvent  (E162)  and  clean  cloths (E120).  Wear  gloves  (E186) and  goggles. 6-613







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.