• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL  COMBINING  TRANSMISSION  OIL  COOLER  FAN  AND  SHAFT 145D5319-7 (Continued) - TM-55-1520-240-23-5_636
REMOVE COMBINING TRANSMISSION OIL COOLER

TM-55-1520-240-23-5 CH-47D Heilcopter Manual
Page Navigation
  601    602    603    604    605  606  607    608    609    610    611  
TM 55-1520-240-23-5 6-186.1 INSTALL COMBINING TRANSMISSION OIL COOLER FAN AND SHAFT 145D5319-7     (Continued) 6-186.1 11. Install fan (2) as follows: a. Coat four studs (5) with oil (E253, E254, or E254.1). b. Lower the fan onto studs (5).  Lightly tap the fan to seat it on oil cooler (6).  Use a rawhide mallet. c. When the fan is seated, install washers (16), bracket (17) (at right stud only), and nuts (7) on studs (5).  Torque the nuts to  100-140 inch-pounds. 12. Coat thread of clamp (18) with oil (E253, E254, or E254.1). Install clamp and duct (19) on fan (2). Torque the clamp (18) to 30-35 inch-pounds. INSPECT FOLLOW-ON MAINTENANCE: Close pylon hinged fairing (Task 2-2). Perform a ground run (TM 1-1520-240-10). END OF TASK Change 1 6-615







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.