• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
REPLACE  AFT LANDING GEAR PROXIMITY  SWITCH  BRACKET (Continued) - TM-55-1520-240-23-3_158
INSTALL  AFT LANDING  GEAR PROXIMITY  SWITCHES,  TARGET,  AND  ADJUSTER LINK (Continued)

TM-55-1520-240-23-3 CH-47D Heilcopter Manual
Page Navigation
  136    137    138    139    140  141  142    143    144    145    146  
TM  55-1520-240-23-3 3-55 INSTALL AFT LANDING GEAR PROXIMITY  SWITCHES,  TARGET,  AND ADJUSTER LINK 3-55 INITIAL  SETUP Applicable Configurations: All Tools: Aircraft  Mechanic’s Tool  Kit, NSN 5180-00-323-4692 Torque  Wrench,  5  to  50  Inch-Pounds Materials: Lockwire  (E231) Personnel  Required: Medium  Helicopter Repairer Inspector References: TM  55-1520-240-23P Task  3-56 NOTE Procedure  is  same  for  left  or  right proximity  switch.   Right  switch  is shown  here. INSTALL PROXIMITY  SWITCH 1. Install  nut  (1) and  lockwasher  (2) on  proximity switch  (3). 2. Position  switch  (3) in  bracket (4).  Install  keying washer (5)  and  nut  (6). 3. Adjust  gap  between  switch  face  (7) and  face of  target  (8)  to  .030  inch to .035 inch.   Use thickness  gage  (Task 3-56). 4. Tighten  nuts  (1  and  6).  Check gap. 5. Install  lockwire  (E231) between  nuts (1  and  6). 3-143







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.