TM 55-1520-240-23-9
11-192
REMOVE FORWARD OR AFT SERVOCYLINDER CONNECTING LINKS
11-192
INITIAL SETUP
Applicable Configurations:
All
Tools:
Aircraft Mechanic’s Tool Kit, NSN 5180-00-323-4692
Workstand
Materials:
None
Personnel Required:
Medium Helicopter Repairer
References:
TM 1-1520-253-23
Equipment Condition:
Battery Disconnected (Task 1-39)
Electrical Power Off
Hydraulic Power Off
Cockpit Controls at Neutral (Task 11-33)
Servocylinder Safety Blocks (T31) Installed (Task
11-28)
Forward or Aft Work Platforms Open (Task 2-2)
NOTE
Procedure is same to remove forward
or aft servocylinder connecting links.
Forward left connecting link is shown
here.
Attaching bolt, washers, and nut will
be temporarily installed after removing
link.
NOTE
If a crack in the connecting links
or bellcranks is suspected during
removal, refer to TM 1-1520-253-23.
1.
Remove cotter pin (1), nut (2), two washers
(3), and bolt (4) from bellcrank (5). Disconnect
forward left connecting link (6) from bellcrank.
2.
Install bolt (4), two washers (3), and nut (2) in
bellcrank (5).
3.
Remove cotter pin (7), nut (8), two washers (9),
and bolt (10) from servocylinder (11). Remove
link (6).
4.
Install bolt (10), two washers (9), and nut (8)
loosely in servocylinder (11).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
11-788
